Jump to content
Corsair Community

Force 120 SATA3 with Linux

Recommended Posts

I am trying to set up my new system. Currently I have only one HD, the new Corsair Force 120. I struggled a lot trying to install a Linux version, but in the end I managed to tweak BIOS and get Fedora 18 64 bit to install without error reports. There was nothing on the SSD disk before, it was new. When I now power up the system, nothing happens, just empty screen with cursor blinking.


In order for the install, I discovered that I had to put my SATA speed down from 6 to 3, and switch from IDE to AHCI for the SATA controller. But now I'm getting worried. The BIOS still sees the SSD disk. I specifically wanted my OS on an SSD drive to make it faster. Am I missing something?

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...