Gman72 Posted March 2, 2013 Share Posted March 2, 2013 for some reason I put the two wire cpu fan header on a chassis M/B fan connector. I want to change that and put the h100 cpu header on the cpu M/B connector itself. I have it connected to corsair link command but I do not have the software installed. its a x79 sabertooth board. Is there any issue regarding using the cpu header on the M/B? Link to comment Share on other sites More sharing options...
Toasted Posted March 2, 2013 Share Posted March 2, 2013 What did you plug into the chassis fan header? The Molex connector plugs into a Molex connector from the PSU. The 3-pin header that comes out from the H100 block connects to the CPU_FAN header to prevent the CPU_FAN error and also give you the same error if the pump fails. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.