Jump to content
Corsair Community

Installed the H60, now my "Windows failed to start"


Recommended Posts

I recently installed the H60 liquid cooling system, which took some time because I'm what you'd call average at component installation and whatnot.


After finicking with my system I finally got the H60 into place spick and span. But upon trying to boot up my PC I go to POST like usual and hit F1, but then it says that "Windows failed to start. A recent hardware or software change might have caused the issue after you install Windows Updates.


As of now I can only boot up my pc successfully with on 4gb dibb of RAM, with two (my usual 8gb total) the system enters the usual POST I hit F1 and I get no signal and I am sent back to the POST.


I'd like to know if anyone else has experienced this, and if there is any advise for me. Thank you

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...