Jump to content
Corsair Community

Does Corsair Link 2 work with windows 7


garryrw

Recommended Posts

Hi I just wanted to ask someone if this corsair link 2 software is supposed to work with windows 7,it is just that with my corsair H80i I had problems with windows 8 when it come to safely ejecting a portable harddrive,I kept getting this message every time I went to eject the haddrive ( the device is currently in use please close any programs or windows that might be using the device and try again)

 

After reading on these forums I read that corsair link 2 doesn't yet support windows 8,which is why I reinstalled windows 7 yesterday to hopefully get full compatibility with the corsair link 2 software.

 

The trouble is even running windows 7 64 bit I am still getting the same message when I try to eject my usb 3 portable harddrive ( the device is currently in use please close any programs or windows that might be using the device and try again)

 

Could I get some advice from someone or maybe even someone from corsair to what might be causing this problem I have with windows 7 and windows 8,and can it be fixed somehow.

 

My system is a z77 motherboard with a 3770k cpu,I have the H80i installed properly with the usb lead plugged into the usb header on the motherboard.

Link to comment
Share on other sites

A new software update may fix it. Alternatively you can create two batch files to stop/start the service for now.

 

when you refer to batch files or bat files as ive always called them,most here are probably lost on how to create one.perhaps a example of one would be helpful.last ones i made was in '87 so as of now im in the lost line:D:

Link to comment
Share on other sites

  • 3 weeks later...

I just saw this thread and was about to post that I was having the exact same issue.

 

In my case (see specs) I went all the way back to a clean install of Win7x64 and Corsair Link was the culprit.

 

This was just the 1st chance I had to post. Thanks for the batch files. I'll test them out later tonight. Haven't run into the Safe Mode issue yet. I'll give that a test too.

 

I'm assuming the "Sierra2" Service is what CL uses to talk to the USB?

 

And I'm using CL version 2.2.0

Link to comment
Share on other sites

  • 3 months later...
::bump::

 

Does anyone know if the latest fix resolves this problem?

 

i can only assume it has fixed ejection issues as since its release i havent seen any problems on the board regarding this issue.

it works on win7 and now also on win8

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...