Jump to content
Corsair Community

Abit an7 and VS512MB400


calvin12

Recommended Posts

I am building an AMD3200+ system on the AN& motherboard. What setting do I need to run the RAM at? Leave them set to spd in the BIOS? what about the voltage? I have 1gig of RAM (2x512). I already have the RAM, the deal was too good to pass up, I am about to buy the board and chip and want to verify that it wil work all right.

 

Thanks

Link to comment
Share on other sites

  • Corsair Employee

Please use the settings bellow!

CPU Freq:200

Dim Voltage: 2.7 Volts

Memory Freq: 100%

Memory Timings: By SPD (should result in the following)

Resulting Frequency: 200MHz

SDRAM CAS Latency: 2.5T

SDRAM RAS to CAS Delay (tRCD): 3T

SDRAM Row Precharge (tRP): 3T

SDRAM Active to Precharge Delay (tRAS): 8T

All other settings are motherboard defaults.

Link to comment
Share on other sites

One more question, Will this memory run in dual channel mode? A friend of mine was at the store today looking to buy RAM and saw a competetors RAM and they had DDR for dual channel and single channel packaged differently. My understanding is that 2 matched sticks will run dual channel if the board supports it. There is no "special" dual channel RAM.
Link to comment
Share on other sites

Please use the settings bellow!

CPU Freq:200

Dim Voltage: 2.7 Volts

Memory Freq: 100%

Memory Timings: By SPD (should result in the following)

Resulting Frequency: 200MHz

SDRAM CAS Latency: 2.5T

SDRAM RAS to CAS Delay (tRCD): 3T

SDRAM Row Precharge (tRP): 3T

SDRAM Active to Precharge Delay (tRAS): 8T

All other settings are motherboard defaults.

 

 

Ramguy,

 

I have been having trouble with my current memory on my Abit AN7 board. I think it's because it is only CAS 3 memory, so I am have been looking at buying some Corsair memory that is CAS of 2.5. My question is why did you tell him to set the coltage to 2.7 when I have seen that PC3200 512MB CAS 2.5 Corsair memory is spec'd to run at 2.5 Volts?

 

Thanks.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...