Jump to content
Corsair Community

setting VDIMM help please


Devil4915

Recommended Posts

Ok so i set my timings at 2.5-3-3-6 which is stock tested at a 400mhz fsb. when i tried loading windows it kept restarting, uped the VDIMM from 2.77 to 2.90. everything is stable now. Is this ok to keep the vdimm at 2.95? btw, the stock cpu fsb is only 333mhz. specs are in my profile... ryan
Link to comment
Share on other sites

  • Corsair Employee
Please set the memory Frequency to 1-1 or at DDR333 with the CPU you have, if you run the memory at DDR400 and the CPU at 333 MHz it will cause a bottleneck in the chipset and may generate errors that are not the fault of the memory! Please load setup defaults and then set the following settings and test with [url]www.memtest.org[/url] CPU Freq: 166 Mhz Memory Frequency: 100% Dim Voltage to 2.7 Volts Resulting Frequency: 166MHz SDRAM CAS Latency: 2.5T SDRAM RAS to CAS Delay (tRCD): 3T SDRAM Row Precharge (tRP): 3T SDRAM Active to Precharge Delay (tRAS): 7T
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...