Jump to content
Corsair Community

Force 3 120 GB intermittent error


Recommended Posts

This was a clean install on a new SSD, every 2 or 3 boots I get a SMART error.

I have changed SATA ports and swapped the cables. Initially I was clearing the CMOS to get the system to boot, however all it requires (so far) is to power off then back on again and the system usually comes up good.

Crystaldisk 4.3 gives a 100% health check with no warnings. Firmware is 1.3.3.

I am at a loss as to what I can do now to confirm where the issues is.:[pouts:

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...