Jump to content
Corsair Community

600T 5.25" Metal Bay Covers and WF/BT Module


bobn

Recommended Posts

Have a 600t with an intel mobo that has a bluetooth /wf module designed to tape behind a plastic bay cover. The 600t covers have metal grills and will cause interference, don't see a way to remove the grille and have anything to tape to. Wonder if anyone has a solution or a source for a plastic bay cover that will snap into the 600t. Since the module is designed to stick to the inside of the case in a nonmetalic area on the front of the case my options seem limited , any suggestions appreciated. The module is 1.2" tall and 3.7" long and 0.5 " thick.
Link to comment
Share on other sites

  • 5 weeks later...
I have the Corsair 600T case with the Intel DX58SO2 motherboard and I placed the wifi/bluetooth module in the bottom 5.25 drive bay directly behind the mesh panel. I've used bluetooth and wifi constantly, and haven't noticed any interference or degradation in signal sensitivity. I didn't use the adhesive tape either, but I am happy with its performance. Hope this helps.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...