Jump to content
Corsair Community

H80 installation - motherboard bracket/mounting holes not 100% tight/flush?


garetjax

Recommended Posts

I noticed when installing my H80 on a LGA1366 build that the motherboard bracket, when screwed down, demonstrates a little bit of movement and there is a small gap between the back of the motherboard and the bracket itself. Is this normal?

 

Shouldn't the bracket be flush against the four mounting holes in the motherboard? Because right now, all the mounting holes on the bracket are not flush against the motherboard even though they have been tightened down.

Link to comment
Share on other sites

  • Corsair Employees
Have you installed the pump yet? If you haven't, put the pump on top of the CPU, when you have properly secured the pump that is when back plate gets pulled back against the back of the motherboard and gets secured as well.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...