abcohen Posted December 1, 2011 Share Posted December 1, 2011 Hello. I recently purchased and installed this drive, have updated to firmware 1.33, but still seem to be unable to reach the rated drive speeds. I have the SSD connected to my SATA III 6 GB/s Marvell 9123 controller with AHCI enabled. I just ran a benchmark a few times and my max speeds were: 400 MB/s read, 250 MB/s write. Is this normal for my controller? P.S. I was unable to get your firmware updater working for the longest time. It wouldn't detect my SSD until I switched my BIOS back to Enhanced IDE instead of AHCI. Then it detected my SSD and I saw that it came pre-installed with 1.33. Link to comment Share on other sites More sharing options...
madnisman Posted December 1, 2011 Share Posted December 1, 2011 Unfortunately yes, this is normal for Marvell controller. Native AMD/Intel SATA controller is recommended. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.