CMP6GX3M3A1600C7 gbt g1 guerrilla

[data68]

good morning

 

I apologize for my English

 

my name is ivan ask for help for a problem with these memories and this motherboard. gbt g1 guerrilla CMP6GX3M3A1600C7

 

If I insert the 3 banks on the motherboard, and reboot the computer power does not turn on.

 

If you only enter the computer is running 2 banks

 

evidence that I should do in the bios to make them go?

 

thanks

[RAM GUY]

I would suggest installing just one module then go to BIOS setup and load setup defaults and then enable XMP and exit saving changes and test them with http://www.memtest.org to be sure its not some other problem.

[data68]

thanks for the answer

 

I'm testing the memory with memtest.

Tonight I try the last memory the other 2 errors 0

 

.updated bios f3

 

 

I sent a request to gigabyte and their answer was this

 

"Thank you again for your kindly reply. About the issue you mentioned, this motherboard supports 6 x 1.5V DDR3 2200/1333/1066/800 MHz memory modules. For memory installation, please refer to the attached Memory Configurations Table. And because there are too many kinds of memory modules available in the retail market, it is very difficult to test all of the modules with our MB products. Thus, we are sorry that we can not guarantee the memory module you mentioned can work properly on this motherboard"

[data68]

I recovered memories compatible kvr1333/2g 3 in their list of supported memories are the kvr1333/4g but the problem may also arise.

I think it's a problem with the mainboard of 3ch.

I will try tonight to put in place cosrsair ch1 ddr3 2.

and assitance contact you the center of gigabytes.

is there any diagnostic program to test the 3 channels?

[RAM GUY]

I would suggest speaking with Gigabyte if you suspect the MB is the issue.