Jump to content
Corsair Community

H50 in 650D


zinzan

Recommended Posts

Quick question regarding installation of the H50 in a 650D. The 650D comes with rubber grommets in the rear fan-mounting holes. With the grommets in place, the screws aren't quite long enough if I use the recommended washers. Should I remove the rubber grommets and use the washers, or should I keep the grommets and not use the washers? I've done the latter for now in order to avoid case noise, but is that asking too much of rubber to hold the radiator in place (without the grommet or the washer, the head of the screw would fit through the hole)?

 

Thanks,

 

-Z

Link to comment
Share on other sites

There should be washers that came with the H50 and you would use the washers instead of the rubber grommets.

 

Okay, thanks. Will do.

 

Follow-up question: is the 120mm case included with the 650D a good match with the 120mm case included with the H50 for a push-pull configuration?

 

-Z

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...