Jump to content
Corsair Community

H100 pre-applied TIM is not centered on block


Ilikebacon

Recommended Posts

I just received my H100 today and I was relieved to see it wasn't from the bad batch listed int the sticky. But, I did notice that the pre applied thermal paste is not centered on the block.

 

It's not offset by much, but since I'm not that knowledgeable on the subject, I figured I should ask you guys if this could possibly cause problems down the road.

 

Here's a pic:

 

http://www.imgplace.com/viewimg850/5029/97offsettim.jpg

 

Thanks!

 

Edit: I also found a fingerprint on said TIM, but common sense dictates the person who left it was wearing gloves.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...