Jump to content
Corsair Community

New purchase, Force 3 60G/90G drives


Recommended Posts

Hi, I just purchased these two drives and so far all is well where I have them installed upon my EVGA E760 Classified mobo connected to a Syba SY-PEX40039 SATA III adapter card installed in an x8 slot where the performance was much better than when installed in an x1 slot. I get around 380MB/s max transfer rate as I'd expect upon the x58 and x8 slot given the limitation of the chipset and controller chip (ASMEDIA 1061). I will move the 60G (which will hold BF3 by itself) to a new Marvell 9128 chip adapter and retain the 90G which has OS boot upon it.


I've now updated both drives to the 1.3.2 fw update (process went w/o a hitch) and that took care of the bogus temp reading error on the 90G but not the 60G, though there is again, no temp issue, both drives being cool as a cucumber. What may be the issue with the 60G on this? Thanks everyone.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...