Help AopenMB Memory Settings?

[Chewtoy856]

MotherBoard = AK77-600GN (Via Chipset) Graphics = Geforce FX 5200 8X 128 Memory Memory = 3X Corsair VS512MB400 System Temperatures = CPU..34C , System..24C , HDD 29C Symtoms = Unstable, Crashing, Dropping To Desktop, Freezing Current Memory Settings, Default On Board DRAM CAS LATENCY......................2.5 BANK INTERLEAVE.........................DISABLED PRECHARGE TO ACTIVE (TRD).........5T ACTIVE TO PRECHARGE (TRAS).......9T ACTIVE TO CMD (TRCD).................5T DRAM BURST LENGTH.....................4 DRAM COMMAND RATE...................2T COMMAND WRITE RECOVERY TIME..................3T DRAM INTERNAL WTRCMD DELAY......2T Power Supply 300W but had the same problems with Asus A7N8X-8 with 350W supply help would be appreciated thanks P.S also tried it with other memory and its fine... and ive tried with 1 stick only and it still freezes

[RAM GUY]

With this list of hardware you really should be using a 400 Watt as minimum! For the timings I would try and set them manually to these settings after you load setup defaults, and any setting not listed should be set to Bios default! Dim Voltage: 2.7 Volts DRAM Timing (overrides SPD values): Manual System Performance: Normal SDRAM Bank cycle time (or tRAS): 8 SDRAM Bank Interleave: 4 ( If you have this setting) SDRAM Row Precharge (tRP): 3 SDRAM RAS-to-CAS Delay (tRCD): 3 SDRAM CAS Latency: 2.5 Then please test the modules one at a time with [url]www.memtest.org[/url] and let’s make sure one is not failing. If you get errors with both modules that would suggest some other issue!

[Chewtoy856]

thankyou for that RamGuy