Jump to content
Corsair Community

Firmware confusion P256


ernestm

Recommended Posts

I have two P256 Corsair SSDs. One is inside my MBP as the boot volume and has firmware VBM18C1Q. The other one (same model) is attached via a SATA link and always used to show its firmware in System Profiler as VBM19C1Q. Until recently, that is. Now it shows VBM1. What gives? I haven't tried flashing firmware on this drive and I can find very little info about revision VBM1. Can anyone clarify this mystery for me? Is VBM1 later/better than VBM19C1Q?
Link to comment
Share on other sites

VBM19C1Q is the latest version for this drive.

 

If you have not tried updating the firmware yourself then it's probably not reading it correctly. I haven't seen VBM1 be reported on its own like that. If the drive is running fine then there shouldn't be anything to worry about, it's just an error in the SMART codes.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...