Jump to content
Corsair Community

Will TR3X6G1333C9 work with Sandy bridge ok?


nitewulf

Recommended Posts

I have 12 GB of XMS3 1333 rated at 1.5V (TR3X6G1333C9). Will this work ok in a new Sandy bridge system I am building? I know you recommend the Vengeance for SB, but I want to use this at least to start with as I already have it on hand.
Link to comment
Share on other sites

You can use these modules well only two of them and only if they are 1.5 Volts module, check the label. But as Wired stated you should not MIX memory.

 

The label on them says 1.50v ver2.1

 

These were installed by a systems builder on an i7 system. It appears 2 GB kits (3x2) were used, they seemed to perform flawlessly on that system so I guess all I can do is give it a try.

Link to comment
Share on other sites

  • Corsair Employees
If you want to add more memory I would encourage you to consider a set of modules that is the density you want to have and just find another use for these to save your self aggravation, but you are welcome to try what ever you like.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...