Jump to content
Corsair Community

TX750W only reading 10.38v


chad711

Recommended Posts

I was told the bios is reading the sensor with no load applied. Once windows loads all the drivers, etc, the volts could be different.

 

Still bios shows 11.72 which is under 12. So does this need replaced?

Link to comment
Share on other sites

I'm pretty much sure the actual voltage is spot on 12V. (if you measured it with a digital multimeter). As mentioned, the software measurements can't be trusted, as they can be off by quite a bit sometimes. Anyway, if your rig is working properly, then there should be no reason to worry.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...