Behlial Posted October 21, 2010 Share Posted October 21, 2010 Good Evening, I sent a ticket in a few days ago, but never got a response. I figured I would try on the forums. I just build a new pc this past weekend, and am having some issues getting the timings correct on the ram. Currently every time I go and attempt to get the ram to 1600mHz, it will not boot/post. Currently the computer is not overclocked. I am more worried about getting the timings and the system to read the ram correctly. Currently it sees all 3 sticks of ram at 1066. Current timings are 8-8-8-24 2T voltage sitting at 1.66V I have tried many different combination of voltage, bclk, and a few other things and still have not been able to get it to read the ram at 1600mhz. Is it possible that the ram is not compatible at all? Any suggestions would be great. Oh the ram passed an overnight run of memtest, as well as it passed Burn In Test, with out any errors or failures. Thanks again! Link to comment Share on other sites More sharing options...
Yellowbeard Posted October 21, 2010 Share Posted October 21, 2010 Have you tried using the XMP profile? If not, give it a try and also, check before and after setting XMP what your CPU/VTT setting is. If your BIOS does not exactly use this term, CPU/VTT you are looking for the voltage to the memory controller. Link to comment Share on other sites More sharing options...
Behlial Posted October 21, 2010 Author Share Posted October 21, 2010 I can give that a try again. Last time I tried it, it didn't post. Let me give it a try, and see. Link to comment Share on other sites More sharing options...
Behlial Posted October 21, 2010 Author Share Posted October 21, 2010 Switching it on and off XMP, I saw that it did not change anything other the the ram frequency as I turned it on and off. No voltage changes everything was set to auto. Link to comment Share on other sites More sharing options...
Behlial Posted October 21, 2010 Author Share Posted October 21, 2010 Going to give it a go again tonight. Would there be any information that would be helpful ? Link to comment Share on other sites More sharing options...
Yellowbeard Posted October 21, 2010 Share Posted October 21, 2010 Clear the CMOS, reboot, enable XMP, and see what happens. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.