Jump to content
Corsair Community

P128 reading 5.9 and starting to go slow.


Poradicus

Recommended Posts

Corsair P128 starting to write slow and Windows Experience Index showing score 5.9. I'm not sure why it degraded fast. I am using Windows 7 64bit with TRIM Enabled and barely downloaded anything to the SSD. VBM19C1Q, is the latest Firmware on the drive. I have a 2nd and third drive where I put my downloads at. Anyone have any ideas of what could be causing this to be degraded soo fast? I only had the drive for 4 weeks.
Link to comment
Share on other sites

Is the drive full of data.

 

How much drive space is left.

 

Have you used the drive for some movie editing ore other write heavy use.

 

If so the nand cells is full of data and this is slowing your drive down.

All the writing is now probably a read - modify - write proses and this is slowing your drive down.

 

A HDD erase would reset the nand cells to factory fresh, But you must re install / re image your OS and aps.

Link to comment
Share on other sites

Ok, I tested the SSD with ATTO again and now it is showing this below in the picture. I had to try another sata cable and plug in another port on motherboard. I'm not sure why it works better when pluging the drive in a different port or using a different cable; but the write and read speeds seem much better than before.

1126257241_BenchmarkSSD09-16-10.thumb.jpg.4f7c19ac9026d3142dd09c0661943e6b.jpg

And to answer E46Johnny Question. The drive space is 97.6 GB free and 21.6 used.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...