Iant Posted September 15, 2010 Share Posted September 15, 2010 Not sure if this is the right section sorry if it isn't! When I go into my bios and set XMP the voltage shows up at 1.66 instead of the 1.65 it is supposed to be and it gives me a warning that anything above 1.65 can destroy my CPU. Is it ok to leave it at 1.66? Should I put it at 1.64? Does it make a difference? Thanks! Link to comment Share on other sites More sharing options...
trackrat Posted September 15, 2010 Share Posted September 15, 2010 The memory will run fine at either 1.64V or 1.66V. It isn't that sensitive to voltage where a couple hundredths of a volt will cause failure. Link to comment Share on other sites More sharing options...
Synthohol Posted September 15, 2010 Share Posted September 15, 2010 i agree... Link to comment Share on other sites More sharing options...
Wired Posted September 16, 2010 Share Posted September 16, 2010 Guys, please don't double post. Threads merged, duplicates removed. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.