Jump to content
Corsair Community

Corsair TW3X4G1600C9D


penfold007

Recommended Posts

I have recently had to take my pc back and the outcome was faulty memory.

unfortunately they did not give me back the box and everything with M/b and CPU docs inside. I am now trying to set up the memory above in the bios. I know the settings are 9.9.9.24 and voltage is 1.8v.

In my M/b bios it says: DRAM voltage control

and: DDR VT voltage control

 

do I just set the DRAM voltage to 1.8v?????????

at the moment it is set as (normal) then at the side greyed out 1.500V

and DDR VT set as (normal) then at the side greyed out 0.750V

 

when I try to set the DRAM voltage to 1.8V it flashes red as a warning, so not sure if I am doing it right???. Any help would be most appreciated

 

just as a foot note, have looked on the corsair site and for the TW3X4G1600C9D it says 9.9.9.24 1.65V, but on the sticks of memory I have it says 9.9.9.24 1.8V, curoius???????

Link to comment
Share on other sites

penfold,did you try runnin it yet? If so what volts and what happend? I would at least try it at 1.65 put your 9.9.9.24 in manualey,and go from there.someone will proubley get with you if you have trouble.
Link to comment
Share on other sites

Yes set as I said 9.9.9.24 and 1.8V as it says on the side of the memory.

Its been running for 5 hours up til now with no problems.

could do with a bit more ino on this though as I'm not 100% sure of it.

I think that its 1.8V because its version 2.4 of the memory, or so I've read somewhere earlier, but again not 100% sure of these settings???????

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...