Jump to content
Corsair Community

very strange error


claudio.mannino

Recommended Posts

Hello guyz, I have a little problem with these sticks of RAM and my mobo.

 

This is what happeans: when i install all 4 sticks of ram, there is no post and no beep. i test each stick separately with memtest86 v4 on each slot and no error were found. it's like the mobo cannot go over 6 gb of ram. in fact when i take off a stick(any of them) , the mobo run with no problem. i test the sticks with all auto settings in bios. i also try to run the stick at 667 mhz, 2.0 volt and the nb at 1.3(from a default value of 1.2). i also try to set some timing in manual mode(5-5-5-18) but nothing happend.

This the report of BIOS RAM settings:

 

1st information

tCL =5

tRCD =5

tRP =5

tRAS =18

tRRD =3

tRFC =52

tWR =6

tRTP =3

 

2nd information

tRTW=8

tWTR_S=3

tWTR_D=5

tRTR_S=4

tRTR_D=6

tWTW_S=4

tWTW_D=7

 

3rd information

tWTPD=14

tRTPD=5

tPTPD=1

tAPTAD=6

tAPTRD=6

 

I hope there is someone who can help me..

 

Thnx Guys

 

Best regards

Claudio Mannino

Link to comment
Share on other sites

  • 2 weeks later...
  • Corsair Employees
With 4 modules I would suggest setting the memory frequency at DDR667 and set the memory Voltage to 2.0 Volts and set the NB/MCH/SPP Voltage to +.2 Volts as well and test the system with http://www.memtest.org. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...