Jump to content
Corsair Community

How to get CMD4GX2M2A1066C5 to 1066


xan175

Recommended Posts

Hi I can't seem to get my pack of CMD4GX2M2A1066C5 up to 1066MHZ. I'm not all too savy with over clocking and settings but i went into bios and manualy changed it to the 1066 setting and all i got was a black screen after that and had to reset cmos to get my computer back to life. I've tryed updating my BIOS to the newer version and figure i'd check in here before i try again
Link to comment
Share on other sites

what are your voltages at?

1.91 is the Dram voltage, i tryed to bump it up to 2.1 like the spec sheet said and it didnt change anything so i put it back. The timings are 5-5-5-18-2T its saying 401.8Mhz is the DRam freq. at the moment.

 

Its funny because i go into CPU-Z and it has the timings for 533Mhz listed and everything and says 2.1Vs but it says 5-6-6-18-2T are the correct timings

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...