Jump to content
Corsair Community

TWIN2X4096-6400C5C = No Post


Recommended Posts

Got 2x 2GB XMS2 DDR2 800 to replace the RAM that failed in my system. Installed both sticks and no POST. Took out one stick and my system booted up fully and was fine, tried the other stick in by itself to make sure it wasn't dead but it also worked fine by itself. It seems that the system doesn't POST only when I put them BOTH in. So, what should I do?


...tried upping the voltage to 1.95v and that didnt do anything.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...