Jump to content
Corsair Community

Problem with one memory module from 2 pairs of TWIN2X2048-8500C5DF


Max ROCKSTONE

Recommended Posts

Hello, I got 2 pair of CM TwinX2 8500D whose one is a SLI named at 2.2 volt and the other one not bought at the same store 2.1 volt. On gour modules three ran well but one does not work at all, even alone and on all the four spots. I tried out with one, then two, then three modules... still OK. When I fit the fourth, the system boot and reboot without passing by the BIOS. You can stop the PC only when power off the PC. I think this module is out, what do I have to do ? Asking for a RMA ? Thanks for help, ideas.
Link to comment
Share on other sites

  • Corsair Employees
With 4 modules I would suggest setting the memory frequency at DDR667 or DDR800 and set the memory Voltage to 2.1 Volts and set the NB/MCH/SPP Voltage to +.2 Volts as well and test the system with http://www.memtest.org. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...