billyb0b Posted October 11, 2009 Share Posted October 11, 2009 Does anyone know what size and length of screw I would need to run a 120x120x 20mm fan on the H50? The fan is a Yate Loon that's just 20mm thick, compared to the 25mm fan that Corsair provides. I don't want to put the stock screw (6 x 32 x 1 1/4") through this thing because it will be too long. I'm going to be doing two of these 20mm thick Yate Loon fans in a push/pull config. Thanks!:cool: Link to comment Share on other sites More sharing options...
Hedghawg71 Posted October 11, 2009 Share Posted October 11, 2009 Go to the hardware store and go through the 6/32 bolt bins until you find one that when you stick it through the fan mounting holes it only protrudes like 1/8 of an inch. If it's border line too long, just washer it up a little with those thin brass washers that would also be in the bolt bins at the hardware store. You may be out of pocket mmmmm $2.00-$3.00 total and have left overs parts too. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.