vega22 Posted September 13, 2009 Share Posted September 13, 2009 Right now im fully stable with this settings 1.68v 201 BCLK x8 RAM multiplier (1608 Mhz) DRAM Command Rate: 1N CAS Latency Time (tCL): 6 RAS# to CAS# Delay (tRCD): 7 RAS# Precharge (tRP): 6 Precharge Delay (tRAS): 18 REF to ACT Delay (tRFC): AUTO Write to PRE Delay (tWR): AUTO Rank Write to Read (tWTR): AUTO ACT to ACT Delay (tRRD): AUTO Row Cycle Time (tRC): AUTO Read CAS# Precharge (tRTP): AUTO Four ACT WIN Time (tFAW): AUTO Ch1 Round trip latency: AUTO Ch2 Round trip latency: AUTO Ch3 Round trip latency: AUTO tREFI: AUTO I need 1.68v because the subtimings being implemented by the DFI in AUTO are very aggressive. I want to limit the voltage @ 1.65v, setting manually the SPD subtimings for this memory @ 1600 Mhz. What values should I use? Thx. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted September 14, 2009 Corsair Employees Share Posted September 14, 2009 I need 1.68v because the subtimings being implemented by the DFI in AUTO are very aggressive. I want to limit the voltage @ 1.65v, setting manually the SPD subtimings for this memory @ 1600 Mhz. What values should I use? Thx. Any setting not listed should be set to AUTO or BIOS default and these settings you are asking about are chipset settings and may be different for other chipsets. If you want o learn about these settings I would suggest go to http://www.rojakpot.com and getting the BIOS optimization Guide. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.