tllewellin Posted September 5, 2009 Share Posted September 5, 2009 Just purchased the above, and although the memory was in the approved list for the motherboard, a note in the manual states memory should not run at greater that 1.65 volts with the intel chip. The memory modules are listed as 1.7 volts, but written on the chip is 1.50 volts (vers 9.1). I have not opened the memory yet, as I am now unsure of the compatibility..... Help suggestions are welcome. Tim :confused: Link to comment Share on other sites More sharing options...
Wired Posted September 5, 2009 Share Posted September 5, 2009 If it says 1.5v on the stick itself you'll be ok, however you should really use a TRIPLE stick pack for a triple channel system. With a TWO stick pack you'll be limited to dual channel. Link to comment Share on other sites More sharing options...
tllewellin Posted September 6, 2009 Author Share Posted September 6, 2009 If it says 1.5v on the stick itself you'll be ok, however you should really use a TRIPLE stick pack for a triple channel system. With a TWO stick pack you'll be limited to dual channel. Thank you, yes realised the difference after purchase Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted September 10, 2009 Corsair Employees Share Posted September 10, 2009 I would suggest getting the TR3X3G1333C9 for that MB, you might talk to the reseller and see if they will let you get the right part since you have not opened these yet. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.