Jump to content
Corsair Community

Asus P5K Deluxe help


Chor

Recommended Posts

Hello,

 

I had bought Corsair Dominator the TWIN CM2X2048-8500C5D, and I had seen in the compatibility thread that works with P5K-Deluxe, but when I start my PC nothing happens the pc does not load nothing.

 

I found some threads talking about the voltage, but I don't know how to set up this.

 

I need some help with that, please.

 

Tks!

 

Ps.: Sorry for the bad english I'm from Brazil

Link to comment
Share on other sites

No, I'm tyring to put just the dominator pack, any other memory are inserted on my MB.

 

I had an 2GB memory already but I'm not gonna use it anymore, I'll use just use the Dominator pack, but when I put to work the pc does not start.

Link to comment
Share on other sites

  • Corsair Employees
Please go to BIOS setup and load setup defaults with the current memory installed and then exit the BIOS saving changes and then when the screen goes blank and before it starts to post turn it off. Then install just one of the new modules after you remove the old memory and see if it will post and let you into the BIOS, if so just load setup defaults and set the tested settings and then test them one at a time with http://www.memtest.org
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...