Jump to content
Corsair Community

MSI P7N Diamond + TWIN2X4096-8500C5DF


ricardo mollik

Recommended Posts

Hi,

I have a MSI P7N Diamond and i have installed one pairs of the above mentioned memory TWIN2X4096-8500C5DF Module. The thing is that i have yet to overclock but i cannot seem to get the modules to work at 5-5-5-12 at 2.1 volts.

The memory settings of the bios are:

 

SLI-READY memory= Expert

Memory voltage: 2,1v

and inside that i have set the following manually:

 

CAS 5

TRCD 5

TRP 5

TRAS 15

CR 2T

 

The modules work great but even with the above settings saved in the bios, when i check with CPU-Z i get

 

CAS 5

TRCD 5

TRP 5

TRAS 18

CR 2T

 

the pc will freeze on boot up, game load up or sometimes in game. Suggestions?

Link to comment
Share on other sites

You're reading the wrong tab. Look at the MEMORY tab.

 

sorry :D:

attachment.php?attachmentid=5869

 

what would be best setting for these memory's .

to mode EEP is automatic?

 

DRAM Frequency ..................... [1066mhz]

 

Advance DRAM Configuration: Manual

1st

CAS# Latency (CL) : 5

TRCD : 5

TRP : 5

TRAS : 15

TRRD : Auto

TRC : 22

TWR : Auto

TWTR : Auto

TREF : Auto

1T/2T NENORY TIMING : 2T

 

CPU Voltage ........................ ........[Auto]

DRAM Voltage ...............................[Auto]

NB Voltage ...................................[Auto]

SB Voltage .... ..............................[Auto]

NB Memory Reference Voltage ..........[Auto]

Memory Reference Voltage................[Auto]

Memory Terminator Voltage ..............[Auto]

CPU GTL Reference Voltage ..............[Auto]

NB GTL Reference Voltage.................[Auto]

FSB Terminator Voltage ...................[Auto]

NB Memory Reference Voltage ..........[Auto]

SB Sleep Mode Voltage.....................[Auto]

PCIe Expander PLL Voltage ...............[Auto]

 

CPU Spread Spectrum ................ [Enable]

memory.jpg.3841f47f9d59837b695ff7f4c4d23c95.jpg

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...