Jump to content
Corsair Community

2 pairs of TWIN2X4096-8500C5D - Not Working


SEAL-KillerXXL

Recommended Posts

I have 8Gb of Corsair RAM...When I`ve installed it on my MoBo,there was a lot of BSODs & errors...Memtest-full of errors.When I took out one stick-everything works normally with 6Gb...I have already tried to change voltages on NB,RAM,CPU...Timings on Auto(5-5-5-18).How to fix it?

P.S.& my RAM can`t normally works at 1066Mhz...

Link to comment
Share on other sites

  • Corsair Employees

This has been posted many times when using 4 modules of two twin sets have you tried this?

With 4 modules I would suggest setting the memory frequency at DDR667 or DDR800 and set the memory Voltage to 2.1 Volts and set the NB/MCH/SPP Voltage to +.2 Volts as well and test the system with http://www.memtest.org. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...