buskalo Posted July 4, 2009 Share Posted July 4, 2009 system doesn't boot or even post when 2 sticks installed. already set the mem voltage to 2.1v but still no go. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted July 6, 2009 Corsair Employees Share Posted July 6, 2009 If both modules will run and pass one up but the MB will not post when both are installed them your MB may not support the speed you are trying to run them at or the MB is failing. Link to comment Share on other sites More sharing options...
buskalo Posted July 7, 2009 Author Share Posted July 7, 2009 thanks for the reply. am sure my mobo is ok coz if i use other dual kit modules it boots up. the mobo website says it can support 1066. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted July 8, 2009 Corsair Employees Share Posted July 8, 2009 I would test a single module in each slot on the board and make sure there is not a slot that is causing the problems. You may also want to test the modules together in a single channel configuration to see if there is any difference. If the modules work together in single channel and you only have problems in dual channel then the memory controller is the likely culprit. Link to comment Share on other sites More sharing options...
buskalo Posted August 11, 2009 Author Share Posted August 11, 2009 thanks again for the replies. i rma'd the mems coz 1 module is defective. tried it in another system. will update once i get back the mems. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted August 11, 2009 Corsair Employees Share Posted August 11, 2009 NP Thank you for letting us know and please do let us know any updates. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.