Jump to content
Corsair Community

System starts and stops twice before full boot


Dae

Recommended Posts

I recently installed a Corsair TX 650W psu into an HP xw4600 workstation. The system will start up and then 1-2 seconds later it will stop. It does this twice and on the third time the system will boot up normally and seems to run with no issue.

 

I have checked all the cables and performed the paper clip test mentioned on this site.

 

I installed a different TX 650W psu, the problem still persists, but I feel confident its not the psu.

 

Any thoughts on why this occurs? Is the system in any danger?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...