Jump to content
Corsair Community

TR3X6G1866C7GTF and DFI LanParty JR X58-T3H6


Recommended Posts

I just shelled out quite a bit of money for RAM I can get up to high speeds, but sadly I am unable to get it to work. The fastest I can get it to run stable is 1333 with 9-9-9-24 timings.

I know that SPD is supposed to set it to 1866 automatically as long as I set the voltage to 1.65. However on automatic settings it runs at 1066.

I have tried setting it at 1600 with automatic timings--this fails memtest.

I have tried setting it at 1866 with automatic timings--this does not post.

I have tried clocking up the FSB to 165 to get the timings up to 1600 from 1333. This will run for a few hours before bluescreening or exhibiting other nasty windows behavior.

I have not had any heat issues with the processor, and while the gpu runs hot, I keep the fan cranked to make it always below 60C.

And I should point out, that since I installed this ram to replace my Cheapo 1066 memory Prime 95 always causes my system to bluescreen no matter what ram settings I use.


Can anyone help me on how to configure this bios to use this ram?

Link to comment
Share on other sites

  • 3 months later...
  • 2 weeks later...


This topic is now archived and is closed to further replies.

  • Create New...