sparkee89 Posted March 12, 2009 Share Posted March 12, 2009 I have a pair Corsair XMS2 CM2X2048-6400C5 5-5-5-18 with a trc of 23 and a voltage of 1.9 Also clocked at 400 but was actually only running at 756 because of my cpu clock divider I think using an AMD 5000+ processor. The problem is at that setting I am experiencing frequent lockups I need help please. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted March 12, 2009 Corsair Employees Share Posted March 12, 2009 Please make sure that you have the latest bios and load setup defaults and then set the memory Voltage to 2.0 Volts then set the timings manually to the tested settings for the specific module you have, and test the modules one at a time with http://www.memtest.org to be sure one is not failing. If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test. Link to comment Share on other sites More sharing options...
DerekT Posted March 13, 2009 Share Posted March 13, 2009 Download Memtest86+ V2.11 from--->Hereand extract the ISO image. Burn the ISO image to an CD-ROM disk. Download CPU-z from Here .Enter your BIOS. Load Setup Defaults. Save Setup Defaults. Set to these values: Advanced Settings CPU Configuration AM2 Boost = Disabled Overclock Mode = Manual CPU Frequency = 212 PCI-e Frequency = 100 Boot Failure Guard = Enabled CPU/LDT Spread Spectrum = Enabled SATA Spread Spectrum = Enabled Cool 'n' Quiet = Auto Processor Maximum Multiplier = 13 Processor Maximum Voltage = Auto Multiplier/Voltage Change = Auto DRAM Voltage = 1.9v Chipset Configuration DRAM Voltage = High Memory Clock = 800Mhz Flexibility Option = Enabled CAS Latency = 5 TRCD = 5 TRP = 5 TRTP = Auto TRAS = 18 TRRD = Auto TRC = Auto TWR = Auto TWTR = Auto TRWTTO = Auto TWRRD = Auto TWRWR = Auto TRDRD = Auto MA Timing = 2T Bank Interleaving = Enabled USB Configuration Legacy USB Support = Disabled for Memtest. Enabled after Memtest. Shut the system down and boot to the Memtest CD. Run Memtest for two full passes, then (If Stable), enter Windows and post screenshots of CPU-z's CPU, Memory and SPD tabs. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.