Jump to content
Corsair Community

dual channel problem


d52232dole

Recommended Posts

I cleared CMOS/BIOS, and installed 1 stick on slot 1, got into windows vista, turned off, installed 2nd stick on either slot 2, worked fine, but only single channel, removed 2nd stick on slot 2 and installed on slot 3, a loop of beep and reboot occurred again. Almost give up now, but still hope another solution..
Link to comment
Share on other sites

  • Corsair Employees
If both of your memory modules will POST and run fine as a single module or with them both in the slots for single channel, then it sounds as if you may need to RMA the motherboard. Most likely you have a weak or failing memory controller.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...