Jump to content
Corsair Community

TWIN2X4096-6400C5DHX problem with Vista?


ehsan7715

Recommended Posts

i have 2 stick 2X2GB XMS2 C5 DHX installed on MA78G-DS3h default setting

5-5-5-18 no overclock

but one stick have problem with vista

it work fine in xp and memtest

but when i run stability test (AMD OverDrive) in vista i have a blue screen:mad:

 

Technical information :

STOP: 0x0000000A (0xBA7FFFF4,0x00000002,0x00000001,0x81ADCAA9)

 

collecting data for crash dump ...

Intializing disk for crash dump ...

Beginning physical memory to disk : 100

physical memory dump complete.

 

but this error never come with another sticks

 

i have problem in dual channel mode too

 

i have various blue screen in vista startup and install too

i test with 2 mobo and cpu and get similar result

 

is this a bad memory??:confused:

Link to comment
Share on other sites

Have you set your DRAM voltage to 1.8v? Set your Northbridge voltage a bit higher as well.

 

Download Memtest86+ V2.11 from--->

and extract the ISO image. Burn the ISO image to an CD-ROM disk.

 

Set to the given values and boot to the Memtest CD allowing for two full passes.

 

Results?

 

 

i have 2 stick 2X2GB XMS2 C5 DHX installed on MA78G-DS3h default setting

5-5-5-18 no overclock

but one stick have problem with vista

it work fine in xp and memtest

but when i run stability test (AMD OverDrive) in vista i have a blue screen:mad:

 

Technical information :

STOP: 0x0000000A (0xBA7FFFF4,0x00000002,0x00000001,0x81ADCAA9)

 

collecting data for crash dump ...

Intializing disk for crash dump ...

Beginning physical memory to disk : 100

physical memory dump complete.

 

but this error never come with another sticks

 

i have problem in dual channel mode too

 

i have various blue screen in vista startup and install too

i test with 2 mobo and cpu and get similar result

 

is this a bad memory??:confused:

Link to comment
Share on other sites

If you pass memtest, then the issue is external to the memory.

 

This Stop error message usually occurs during installation when there was an attempt in kernel mode to touch pageable memory at too high a process internal request level (IRQL). Typically, this error occurs when a driver uses an incorrect memory address. Other possible causes of this error include an incompatible device driver, a general hardware problem, or incompatible software.

 

Have you installed Vista with a single stick of memory. Then update to SP1 and install the second stick.

 

 

yes i do . the bios default vale is 1.8V and memory dont have any problem in memtest

it crash in windows vista only

Link to comment
Share on other sites

I agree with Wired, I don't think it is the memory. I think it is your AMD system and how it reacts with the new VISTA OS and your hardware drivers. This is what the STOP code shows at any rate.

 

However, if you RMA the memory and the new sticks show the same result (as I believe they will) then you can be assured that the problem is not the memory. Then you can contact your motherboard manufacturer and see if they can help you. I don't believe this is a memory issue.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...