Jump to content
Corsair Community

twin2X4096 8500C5D?


saw2814

Recommended Posts

  • Corsair Employees
That is normal the modules you have like most of our aggressive modules will have the SPD set to something the MB can post at with default settings IE DDR800 at 1.8 Volts Cas 5-5-5-18 2T. The tested setting s will need to be manually set or with the setting called SLI Ready memory. Make sure that you have the latest BOS and then go to BIOS setup and load setup defaults and load setup/Optimized Defaults and then set the memory Voltage to 2.1 Volts and set the Command Rate to 2T/N manually and then enable SLI Ready memory and set it to CPU 0% should be all you need to set.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...