Jump to content
Corsair Community

Settings for TR3X6G1600C9 on ASUS Rampage 2 Extreme


brooklynzoo81

Recommended Posts

Download Memtest86+ V2.11 from--->

Download CPU-z from-->

Enter your BIOS, load setup defaults, save setup defaults and set to these values.

AI overclock - Manual
OC from CPU level Up - Auto
OC from Memory level Up - Auto
CPU Ratio setting - Auto

CPU Configuration
CPU Ratio Setting - Auto
C1E Support - Disable
Hardware Prefetcher - Enable
Adjacent Cache Line Prefetcher - Enable
Intel Virtualization Tech - Enable
CPU TM Function - Disable
Execute Disabled bit - Disabled
Intel HT Technology - Disabled
Active Processor Cores - All
A20M - Enable
Intel Speedstep Tech - Enabled
Intel Turbo Mode tech - Disabled
Intel C-STATE tech - Enabled
BCLK Frequency - 133
PCIE Frequency - 100
DRAM Frequency - DDR3 1600MHz
UCLK Frequency - Auto
QPI Frequency - Auto

Dram timing control: 

1st Information 9-9-9-24-x-x-x-x-x-x
DRAM CAS# Latency - 9
DRAM RAS# to CAS# Delay - 9
DRAM RAS# PRE Time - 9
DRAM RAS# ACT Time - 24
All the Rest to Auto

EPU II Phase Control - Full Phase
Load-line Calibration - Auto
CPU Differential Amplitude - Auto
Extreme OV - Disabled

Voltages

Cpu Voltage - Auto
CPU PLL Voltage - Auto
QPI-Dram Voltage - Auto

IOH Voltage - Auto
IOH PCIE Voltage - Auto
ICH Voltage - Auto
ICH PCIE Voltage - Auto

DRAM Bus Voltage - 1.64v
DRAM REF Voltage - Auto

CPU Spread Spectrum - Disabled
PCIE Spectrum - Disabled
CPU Clock Skew - Auto
IOH Slock Skew - Auto

Boot to the memtest CD and test for two full passes. Then, if stable, enter Windows and post your CPU-z CPU/Memory and SPD tabs in screenshots.

 

Hello. What would you recommend for this type of ram? TR3X6G1600C9 with regards to BIOS Settings. Thanks.

Link to comment
Share on other sites

Hello. What would you recommend for this type of ram? TR3X6G1600C9 with regards to BIOS Settings. Thanks.

 

Those settings look right to me. I've the same board and those are the settings I used for the initial startup and testing. My only difference was:

 

Intel HT Technology - Enabled

Active Processor Cores - All

A20M - Disabled

Intel Speedstep Tech - Enabled

Intel Turbo Mode tech - Enabled

Link to comment
Share on other sites

My system is working fine although I do have a Cold Boot/Standby issue.

 

Here is a site where you can get far more detailed help with regading overclocking your CPU and your motherboard idiosyncracies.

 

http://67.90.82.13/forums/showthread.php?t=210275

 

 

 

Thanks for the reply back on this. How have those settings been working for you? Can i apply the same to the 965? i noticed you have the 920. Also since i am running this on all air, i would just like to overclock it to either 3.4 or maybe 3.6, thanks.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...