Jump to content
Corsair Community

Need setting for MSI P35 Platinum with TWIN2X2048-8500C5D


Recommended Posts

I'm quite new here so forgive me if my words is harsh. First of all, I set my FSB mobo to 333Mhz just to work up with my processor. The main point is with my mobo now I'm trying to fully utilize my ram running in 1066Mhz instead of 800Mhz. Right now I'm only getting 1000Mhz speed from my ram after I change the memory ratio. Did I do something wrong? I'm not quite understand about the latency thingy. I can't seem to see how people can get 5-5-5-15 or 5-5-5-18 latency. my mobo doesn't show this except Auto, 1:1.25 / 1:1.5 / 1:1.66 / 1:1 / 1:2 & 1:1.2. I tried so many but to no avail :eyebuldge:eyebuldge:eyebuldge
Link to comment
Share on other sites

Download Memtest Version 2.11 from--->

and extract the ISO image. Burn the ISO image to an CD-ROM disk.

Download CPU-z from-->



Set to these values:


Advanced BIOS Features

Cell Menu

FSB/Memory Ratio

DOT Control = Disabled
Intel EIST = Enabled
Adjust CPU FSB Frequency = 333MHz (1333Mhz QDR)
Adjust CPU Ratio = 8

Advanced DRAM Configuration = Manual

Memory Clock = 1066
Memory Timings = Manual
DRAM CAS# Latency (tCL) = 5
DRAM RAS# to CAS# Delay (tRCD) = 5
DRAM RAS# Precharge (tRP) = 5
DRAM RAS# Active to Precharge (tRAS) = 15
DRAM tRFC = Auto
DRAM tWR: Auto
DRAM tWTR = Auto
DRAM tRRD = Auto
DRAM tRTP = Auto
Adjust PCI-e Frequency = 100Mhz
Auto Disable DIMM/PCI Frequency = Enabled

CPU Voltage = Auto
Spread Spectrum = Disabled
Memory Voltage = 2.1v
NB Voltage = Auto
SB Voltage = Auto
FSB VTT Voltage = Auto

Run Memtest for two full passes, then (If Stable), enter Windows and post screenshots of CPU-z's CPU, Memory and SPD tabs.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...