Jump to content
Corsair Community

TWIN2X4096-6400C5 G Ver. 3.1 problems


Recommended Posts

I built my computer about two years ago. I just upgraded my system with these modules. It worked fine with both sticks for about two days then crashed in windows while I was browsing the web. I restarted my computer to find it will no longer POST. I took out one of the modules and booted fine into a memtest86 disk and successfully ran through all the tests. I then removed that stick and put the other one in to find the system again would not pass POST. I've tried switching the slots with no luck. When putting both sticks in, with the confirmed good one in the first slot, the on-board LED readout displays C1 then C3 and then starts all over again. Am I correct in thinking the second module just died?
Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...