Jump to content
Corsair Community

HX1000W installation Question


Kelgiere

Recommended Posts

On my mother board which is a Asus P6T Deluxe the power connection for the EATXV12 on the motherboard had a cover on it covering 4 of the 8 holes. On my power supply which is the HX1000W there is a 8 pin connector thats really 2 four pin connectors connected together. The manual says those are used for either a P4 or ESPV12 connection. My question is should I break up the 8 pin into 2 4 pins connector and just use the one 4 pin connector in the EATXV12 connection and leave the other 4 covered? or should I remove the cover on the EATXV12 connection and use the full 8 pin connection. Thanks for any help

 

J

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...