Jump to content
Corsair Community

Is there anything wrong with this?


chinthakaru

Recommended Posts

Hi! Guys,

 

I purchased a 4Gb kit of 1066 DDR2's(Model Number TWIN2X4096-8500C5DF).

My motherboard is a Gigabyte GA-EP35-DS3R.

In CPUZ the Frequency of each Memory is shown as533MHz instead of 1066. Is this normal?

Or haven't I done something right?

I've Attached The Separate Screenshots of each of my Memory modules.

 

Thanks in Advance.

mem.JPG.9578fb92cc295d3e011870c350f00624.JPG

Slot1.JPG.5470799c030baf8ca31d6f5d4c3ce619.JPG

slot2.JPG.1ac9b86185cf9920e612b216344847d4.JPG

Link to comment
Share on other sites

Download Memtest86+ V2.01 from--->

Download CPU-z from
.

Enter your BIOS. On the main BIOS screen press Ctrl + F1. You will see the screen flicker. Next select the MB Intelligent Tweaker option. On that screen you will see many additional settings that were not there before. Enter these values:

MIB Intelligent Tweaker (M.I.T.)

Robust Graphics Booster = Auto
CPU Clock Ratio = 8.5
CPU Host Clock Control = Enabled
CPU Host Frequency (Mhz) = 333Mhz
PCI Express Frequency = 100Mhz
C.I.A.2 = Disabled
Performance Enhance = Standard
System Memory Multiplier = 3.2
Hi Speed DRAM DLL Settings = Option 2
DRAM Timing Selectable = Manual
CAS Latency Time = 5
DRAM RAS# to CAS# Delay = 5
RAS# Precharge = 5
Precharge Delay (tRAS) = 15
ACT to ACT delay = Auto
Bank Write To READ Delay = Auto
Refresh to ACT Delay = 0
Read to Precharge Delay = Auto

System Voltage Control

DDR2 OverVoltage Control = +.3V
PCI-e OverVoltage Control = Normal
(G)MCH OverVoltage Control = +.03
CPU Voltage Control = Auto 

Boot to the Memtest CD and allow for two full passes. Please post your CPU-z CPU, Memory and SPD tabs.

 

Results?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...