Jump to content
Corsair Community

ga-ma78ghs2h and 2 cm2x1024-6400 's


filanto

Recommended Posts

I have a new mainboard with the phenom 9550 and when I put the memory into the recommended slots the board beeps then reboots. Each works separately but not together. Is there a more compatible chips from you, I am going to return these and I was upping it to twin 2gig chips. The chips I have are from a matched kit I just have a chip sitting on my desk with the model number on it.
Link to comment
Share on other sites

  • Corsair Employees

Please make sure that you have the latest bios and load setup defaults and then set the memory Voltage to 2.0 Volts then set the timings manually to the tested settings for the specific module you have, and test the modules one at a time with http://www.memtest.org to be sure one is not failing. If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test.

 

If both modules will pass one up but you still have that problem when in D/C that would suggest a problem with the CPU or MB.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...