Jump to content
Corsair Community

Doubt about 975X Platinum Voltage


Recommended Posts

Hi all, my motherboard is a MSI975X Platinum Power Up Edition and i wish to buy a TWIN2X4096-6400C4DHX, this set of memory works with 2.1V and my motherboard default voltage is 1.8V. I can set the motherboard voltage up to 2.1V at the setup but im really afraid that this action damage my motherboard. I really need your help guys.Thx.
Link to comment
Share on other sites

well you know how to set it at 2.1 volts, so i take it you just want some reassurance on this matter.

keep in mind that all ddr boards start with 1.8 volts, not just yours :D:


even when you put the new modules into your board it start at 1.8volts only with higher timings (5-5-5-15)


when setting it to 2.1 volt remember you most likely need to adjust the timings aswell to 4-4-4-12 to gain max performance from these modules!


like most i too had to raise the voltage to 2.1 as you can see in pic


hope this helps for you ;):



Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...