toshyKAa Posted October 20, 2008 Share Posted October 20, 2008 Hello, i need some help guys... Could you give me bios settings for TWIN2X4096-8500C5D v 1.1 to run on Asus Rampage Formula and Intel Q9300!I allready run Memtest, stick by stick and everything is ok.Just need bios settings to run it on 1066 mhz 5-5-5-15.THANKS! Link to comment Share on other sites More sharing options...
007bont Posted October 20, 2008 Share Posted October 20, 2008 Hi and welcome, please load up setup defaults in the bios and set the following items: Ai Overclock Tuner : Manual Ratio CMOS Setting : 7.5 FSB Strap to North Bridge : Auto FSB Frequency : 333 PCI-E Frequency: 100 DRAM Frequency: DDR2-1066) DRAM Command Rate : 2T DRAM Timing Control: Manual CAS# Latency : 5 RAS# to CAS# Delay : 5 RAS# Precharge : 5 RAS# ActivateTime : 15 RAS# to RAS# Delay : Auto Row Refresh Cycle Time : Auto Write Recovery Time : Auto Read to Precharge Time : Auto Read to Write Delay (S/D) : Auto Write to Read Delay (S) : Auto Write to Read Delay (D) : Auto Read to Read Delay (S) : Auto Read to Read Delay (D) : Auto Write to Write Delay (S) : Auto Write to Write Delay (D) : Auto Write to PRE Delay: Auto Read to PRE Delay: Auto PRE to PRE Delay: Auto ALL PRE to ACT Delay: Auto ALL PRE to REF Delay: Auto DRAM Static Read Control: Auto Ai Clock Twister : Auto Transaction Booster : Auto CPU Voltage : Auto CPU PLL Voltage : Auto North Bridge Voltage : Auto DRAM Voltage : 2.1 FSB Termination Voltage : Auto South Bridge Voltage : Auto Loadline Calibration : Enabled CPU GTL Reference : Auto North Bridge GTL Reference : Auto DDR2 Controller REF Voltage : DDR2_REF SB 1.5V Voltage : Auto CPU Spread Spectrum: Disabled PCIE Spread Spectrum: Disabled After that boot from CD with Memtest and let it run for 2 full passes. please post cpuz screenshot (of the memorytab) Link to comment Share on other sites More sharing options...
toshyKAa Posted October 21, 2008 Author Share Posted October 21, 2008 running 100% prfect :D thnx u guyz :) Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted October 21, 2008 Corsair Employees Share Posted October 21, 2008 NP Thanks for letting us know! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.