Cm2x1024-8500c5d + ga-ep43-ds3l

[felipeBR]

hello ram guy...i'm from brazil and my english is not good...well...let's go

 

i read the other post about the problem with this memory...CM2X1024-8500C5D

 

2 modules in 1,3 slots: i set values 5-5-5-15 , 2,1V and CR:2T...dont boot:sigh!:

 

2 modules in 1,3 slots: i set frequency 1066 to 800mhz and values 5-5-5-18, 1,8 or 2,1 v, cr:2T and dont boot...:sigh!:

 

1 module : but 1 stick the boot works fine, but the other module dont post..what happening?

 

1 modules : and the stick (with problem) in other motherboar (GA-945GCM)..the boot is ok, but the size = 512mb...e no 1024...:confused:

 

the stick is new, i buy but can use......sugestions???

[RAM GUY]

Let's get them replaced, please use the On Line RMA Request Form and we will be happy to replace them.

[felipeBR]

the quad core work 9*266 ok??

 

8500c5d ... d = DHX ok??

 

if i set the frequency memory to 800 i need set the 266*3 = 798mhz..ok??

 

or set 200*2: 400mhz (if is dhx 400x2 = 800mhz...is correct??)

 

or set 200*4 = 800mhz ??

 

and the configuration 5-5-5-18, and command rate(cmd) = 2t? in the bios the options are (1,2,3)

 

voltage is 1,8 or 2,1 v??

[RAM GUY]

Thwin2x2048-8500C5XX modules should be run at 2.1 Volts, the tested settings can be found from the link in my signature and you should set them manually and test the modules one at a time with http://www.memtest.org to be sure one is not failing.