Jump to content
Corsair Community

Size of the plumbing?


kobwo

Recommended Posts

Try [URL=http://www.sharkacorp.com/Merchant2/merchant.mvc?Store_Code=SOS]Sharka Sales[/URL] as they carry a wide selection of fittings and I know for a fact they have the ones you need and yes, the inner size is 1/4"
Link to comment
Share on other sites

[quote name='kobwo']The specs say that the tubing is 3/8 [I]outer[/I] diameter. Is the inner 1/4". I need to buy the fitting to plumb other blocks into the system. Thanks Kobwo[/QUOTE] Kobwo, The tubing to the cold-blocks are 1/4" ID to fit 1/4" barb-fittings. The OD could be 3/8" up to 1/2" for the tubing wall thickness. Thus, what ever you decided to use for the OD, make sure the clamps will work in that range. Stev
Link to comment
Share on other sites

Hardcore water coolers see the pencil-thin tubing on the HC200 and scoff. But check the tubing inside the guts, between the pump and radiator. It is much thicker. If anything, the smaller diameter of the inlet and outlet hoses increases flowrate to the block. You can bet the Delphi engineers did all the calculations to get everything optimum.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...