Jump to content
Corsair Community

A8N32-SLi with 3500LLPRO


Recommended Posts

Hey all, wondering how to properly setup 3500LLPRO (3G worth) in my A832-SLi mobo. I have 2 1024 sticks (slots 1/3) and 2 512 sticks (slots 2/4). Right now everything is at auto in the bios except the ddr voltage, which is set to 2.75v. I really don't want to mess with the CPU settings, if will if I must to get the 3500 to run as it was supposed to. I have a AMD FX-60 for the brain and would like to keep it running at stock. Here's what I see in CPU-Z (version 1.46) under memory tab (top to bottom, left to right):


Type: DDR

Channels #: Dual

Size: 3072 MBytes


DRAM Frequency: 200.9MHz


CAS#: 2.0

RAS# to CAS#: 3

RAS# Percharge: 2

Cycle Time: 6

Bank Cycle Time: 11

Command Rate: 2T

DRAM Idle Timer: 16


Now I now these puppies are supposed to run 2-3-2-6 timings but is 200.9MHz frequency right? And under the SPD tab (back in CPU-Z) shows Max Bandwidth of PC3200 (200 MHz). Is that right? By the way, I have had these for a while now and have had no problems whatsoever, just wanted to make sure these are doing what they were meant to be doing at the speed they were meant to be going. Just been procrastinating for so long to post something. So please, be detailed with any instructions you gonna dish out, especially if you gonna make me do BIOS settings. Thanks for any help you all can give.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...